(1) 40 pin version LCD which is commonly used in previous version of TFT Mega shield for Arduino MEGA 2560
(2) 32 pin version LCD which is commonly used in STM32 development board(unsoldered)
The shield route all the LCD data pins to port PC1-PC8 and PC12-19, control pins to PD0-PD3, this design can achieve high speed data transfer (three cycles per write strobe to the LCD) to maximize LCD display speed. The SPI interface (for SD or flash control) is route to the ISP header of arduino DUE, so that high speed SPI transfer with DMA can be achieved.
Drive TFT LCD on arduino DUE by just plugging into arduino DUE main board, no flying wires.
Compatible with 40-pin version LCD, which is commonly used in TFT Mega shield.
Also compatible with 32-pin version LCD, which is commonly used in STM32 development board.
On board SD card slot with adjustable CS selection.
On board SPI flash footprint with adjustable CS selection, for upgrade include Font IC to draw text to the LCD and also support SPIFlash library.
LCD power 3.3V and 5V selectable through solder jumpers.
LCD Backlight (LEDA+) 3.3V., 5V or PWM selectable through solder jumpers.
Pins are routed to reduce CPU cycles, i.e. display speed is faster.
The shield is compatible for Arduino DUE and the following LCD:
2.2" TFT LCD module (220×176)
2.8" TFT LCD module (320×240)
3.2" TFT LCD module with font IC (320×240)
3.2" High Resolution TFT LCD Module with font IC (480×320)
3.5" TFT LCD module with font IC (480×320) (full viewing angle IPS panel)
4.0" TFT LCD module with font IC (480×320)
4.3" TFT LCD module with font IC (480×272)
5.0" TFT LCD module with font IC (800×480)
7.0" TFT LCD module with font IC (800×480)
Board Size: 94 * 54 * 20mm / 3.7 * 2.1 * 0.8in
Weight: 27g / 1.0oz
Package Size: Approx. 10 * 6 * 2cm / 3.9 * 2.4 * 0.8in
Package Weight: Approx. 31g / 1.1oz
1 * TFT/SD Shield for Arduino DUE